ATTO Technology FC-3321 Guia de Configuração descarregar pdf (Página 7)

Installing an ATTO ExpressPCI-FC 3321 Adapter

To install an ATTO ExpressPCI-FC 3321 adapter board:

1. Locate an ATTO ExpressPCI-FC 3321 adapter board.

2. Remove the adapter board from the antistatic bag.

3. Insert the adapter board into a slot in the LANserver EX enclosure.

Make sure the slot cover aligns correctly.

4. Push the adapter board into the slot. Make sure the adapter board is

seated completely in the slot.

5. Replace the slot cover screw to hold the new adapter board in place.

6. Repeat steps 1 through 5 for each ATTO ExpressPCI-FC 3321 adapter

board.

Do not run the LANserver EX system without the board retainer bar.

The board retainer bar ensures that the boards are seated properly in

their slots. Running the LANserver EX system without the board

retainer bar can cause intermittent problems.

7. Reinstall the board retainer bar. Make sure the drive controller boards

are vertical. They must be in the left groove on the board hold-down

arm when looking at the LANserver EX from the front.

8. Align the board retainer bar and replace the board retainer bar screw.

9. To replace the cover, slide it onto the enclosure.

10. Secure the cover with the hold-down screw.

11. Close the LANserver EX front door.

12. Boot the LANserver EX system.

Do not connect the Fibre Channel cable to the ATTO ExpressPCI-FC

3321 adapter board. The ATTO Phantom Device does not install when

the cable is connected.

0575101A_IN.fm Page 7 Thursday, March 13, 2003 4:13 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

ATTO Technology FC-3321 Guia de Configuração Página 7