ATTO Technology FC-3321 Guia de Configuração descarregar pdf (Página 11)

Connecting the Fibre Channel Cables

17. Select the ATTO Phantom Device in the Select a Device Driver screen.

If you do not see the ATTO Phantom Device in the list in the Select a

Device Driver screen, click Back, close all open dialog boxes, and repeat

steps 11 through 17.

18. Click Next. The Start Device Driver Installation screen appears.

19. Click Next. The driver installs and the Completing the Upgrade Device

Driver screen appears.

20. Click Finish.

21. Click Close in the ATTO Phantom Device Properties dialog box. The

ATTO Phantom Device Properties dialog box closes, and the ATTO

Phantom Device appears in the System devices list.

22. Repeat steps 5 through 21 for each ATTO Phantom Device.

23. Eject the floppy disk from the LANserver EX floppy drive.

24. Reboot the LANserver EX system.

When you do not have a Fibre Channel cable connected to a port on the

Fibre Channel adapter board, an error message is placed in the System

Event log.

Connecting the Fibre Channel Cables

After the ATTO ExpressPCI-FC 3321 adapter board driver and the ATTO

Phantom Device are installed, you can connect the Fibre Channel cable to

the ATTO ExpressPCI-FC 3321 adapter board.

To connect the Fibre Channel cable to the ATTO ExpressPCI-FC 3321

adapter board:

1. Locate the optical cable. Look for a cable with a dual plug on the end.

2. Make sure the optical cable has an LC (small) optical cable connector

to match the connector on the Fibre Channel adapter board. If the

optical cable connector is not the correct one, contact your optical

cable installer to arrange for them to change the optical cable

connector.

0575101A_IN.fm Page 11 Thursday, March 13, 2003 4:13 PM

1 2 ... 6 7 8 9 10 11 12 13 14

Sem comentários

ATTO Technology FC-3321 Guia de Configuração Página 11