ATTO Technology 2390D Guia de Configuração descarregar pdf (Página 20)

The storage can be connected to the workstation through either 2 FC loops or 4 loops.

2-loop configuration: On ATTOcards 2 micro chips handle fiber traffic to the four ports: chip A handles

ports 1 and 2 and chip B handles ports 3 and 4. To get maximum storage performance in a 2 loop

configuration, the fiber loops should be distributed across the two chips.

Autodesk recommends the following connections:

1 ATTO Port 2 to Dot Hill port A0

2 ATTO Port 3 to Dot Hill port B0

You can also use the two outer ports on the FC adapter card, if they're not used to connect to a SAN or

archiving device.

1 ATTOPort 1 to Dot Hill port A0

2 ATTOPort 4 to Dot Hill port B0

4-loop configuration: A 4-loop configuration uses all four ports available on theATTOfibrechannel adapter

card. If you want to also connect your workstation to a SAN or an archiving device, you will need to install

a second FC adapter card into your workstation.

Connect the FC loops as follows:

■ ATTOPort 1 to Dot Hill port A2

■ ATTOPort 2 to Dot Hill port A0

■ ATTOPort 3 to Dot Hill port B0

■ ATTOPort 4 to Dot Hill port B2

Connect media storage | 15

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 100 101

Sem comentários

ATTO Technology 2390D Guia de Configuração Página 20